Before proceeding, finish all the plywood pieces. to keep them from sagging under heavy loads. The shelves should be no longer than 36 in. shorter than the distance from the top of the base to the ceiling. Crosscut the case sides to length, making them 2 in. plywood to width for the case sides and shelves using a table saw or circular saw and straightedge guide. Also drive angled screws through the inside of the base and into the floor. Set the base into position and check for level right to left and front to back. taller than the baseboard molding you plan to install to make sure the molding slips in easily. less than the depth of the bookcase itself. Start by building a base out of 1x or 2x lumber. The mahogany was $7 per board foot-and certified by the Forest Stewardship Council. The Right Wood: Birch veneer plywood is ideal for building bookcases, and it was affordable at $45 per 4 x 8-ft. But the quickest, easiest approach would be to use a pneumatic finishing nailer-then fill the nail holes with putty. I chose to attach the wooden face frames-stiles, rails, valance and aprons-to the plywood cases with a biscuit joiner so that fasteners wouldn't mar the mahogany. While books generally fit on 8- to 9-in.-deep shelves, I prefer deeper bookcases, so I ripped the plywood to a width of 11 7/8 in. As a rule, a bookcase with shelves between 7 in. War of the Walkers adds other survivors, so if you’d like to avoid that, then maybe Valmod is a better choice. Both mods add new items and new zombies, so you need to see which flavor of those you prefer. So I measured my books before I decided how tall the shelves should be. Now, in terms of which of these two mods you should get, that wholly depends on you and what you’re after. Since the shelves were going to be glued and screwed into the dadoes, they couldn't be adjusted later. The shelves fit into dado joints routed into the case sides. (In contrast, the horizontal mahogany apron attached to the front of each shelf overhangs the plywood.) I separated them with 1/2-in.-thick plywood strips, so that when I attached the 2-in.-wide mahogany stiles, they'd align flush with the plywood sides. Two pieces of plywood form each side of the cases. On permanent display: mahogany, solid biscuit joints-and a whole lot of class.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |